Removing and installing centre floor covering, double cab — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

Don't miss

• Remove tool box and warning triangle.
• When installing the floor covering in the middle (1), make sure it overlaps (2) with the floor covering at the front (3) correctly.The right-hand side is mirror-inverted.

📋 Procedure

1. Switch off ignition.
2. Remove tool box and warning triangle.
3. Remove bracket for vehicle jack.
4. Remove left and right front seats .
5. Remove centre console .

6. Remove cup holder .
7. Remove rear left and right step insert .
8. Remove entire bench seat together with fittings on left and right .
9. Remove lower left and right C-pillar trim .
10. Remove rear centre seat belts .
11. Lift floor covering (1) in (direction of arrow), and remove it from the vehicle through rear door.
12. Pre-position middle floor covering (1) without folding through the rear door and lay it out in vehicle in (direction of arrow). [Note: When installing the floor covering in the middle (1), make sure it overlaps (2) with the floor covering at the front (3) correctly.The right-hand side is mirror-inverted.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing lever and spring for engaging Bowden cable/seat longitudinal adjustment
• Removing and installing rear seat backrest - multi-contour seat
• Removing and installing mounting/centre armrest - country-specific version
• Removing and installing module carrier with lumbar support air cushions - up to 08.2012
• Removing and installing module carrier – Audi A6/A7 C7