Removing and installing bumper cover - Audi RS 3: Audi A3

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

Don't miss

• Loosen the bolts on the bumper cover mounting if you are having difficulties pulling the side section out of the fasteners.

📋 Procedure

1. Remove wheel spoiler (front) .
2. Unplug central connector (arrow).
3. Place drip tray underneath connection point for fluid hose.
4. Press release button and detach headlight washer fluid line (1).
5. Seal hose connection with clean plug from engine bung setVAS 6122.

6. Press unfastened wheel housing liner to side and remove bolts (2 and 3).
7. Remove bolts (1 and 2).
8. Detach side section (3) from side panel (front) (arrow) and detach bumper cover towards the front with the help of a second mechanic. [Note: Loosen the bolts on the bumper cover mounting if you are having difficulties pulling the side section out of the fasteners.]
9. Loosen bolts (1).
10. Align bumper cover (front) longitudinally according to markings (arrow).
11. Tighten bolts.
12. Check that gap width is even and repeat adjustment if necessary.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing wire for side airbag
• Removing and installing refrigerant lines from connection point to rear expansion valve
• Removing and installing right centre vent control motor V111
• Removing and installing retainers for right control motors (with a "“Mix”" or "“High”" air conditioner)
• Removing and installing ATF lines – Audi A6/A7 C7