Removing and installing bumper cover - Audi RS 4: Audi A4 B8

🧭 Before you start

Fits: Audi A4 B8 (8K, 2007–2015)

Don't miss

• Detach bumper cover (1). When doing so, electrical wiring harness must be guided out at opening in body.

📋 Procedure

1. Remove tail lights Electrical system94Tail light cluster; Removing and installing tail light cluster.
2. Unplug main connectors (1).
3. Push grommet (2) through to the outside.
4. Detach cover.
5. Unscrew nut (2).

6. Unscrew bolts (1) on bottom section of bumper cover.
7. Unscrew bolts (arrows) and press wheel housing liner (1) to the side.
8. Remove bolt (2).
9. Pull out locating pin (2) upwards (arrow A).
10. Detach side sections of bumper cover (left and right) from side panel (arrow B).
11. Detach bumper cover (1). When doing so, electrical wiring harness must be guided out at opening in body.
12. Install tail lights Electrical system94Tail light cluster; Removing and installing tail light cluster. [Note: Equipment version with lane change assist: If the bumper cover has been removed, the lane change assist system must be calibrated Electrical system96Lane change assist; Calibrating lane change assist.]

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing mounting bracket and outer door handle
• Measuring return flow rate of injectors with engine running
• Removing and installing high-pressure pump - vehicles from 08.2005 onwards
• Removing and installing high-pressure pumps – Audi 5.2 · 1 torque figures
• Re-determining shim "“S"4” when renewing bearing housing · 1 torque figures