Removing and installing bracket for knee bolster on front passenger side (country-specific version) — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

Don't miss

• Electrical connector (A) does not have to be unplugged.
• When turning right vent temperature sender G151 make sure that seal (C) is not pinched.

📋 Procedure

1. Remove glove box .
2. Remove right vent temperature sender G151.
3. Remove bolts (2) and (4).
4. Detach bracket for knee bolster from central tube (1).
5. Remove glove box .

6. Remove bolts (6) and (7).
7. Detach bracket for knee bolster from central tube (1).
8. Turn right vent temperature sender G151(item B) 90° in direction of (arrow).
9. Remove right vent temperature sender G151 from air duct. [Note: Electrical connector (A) does not have to be unplugged.]
10. When turning right vent temperature sender G151 make sure that seal (C) is not pinched.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing heater housing (right-side) together with retaining plate (right-side) for control motors
• Removing and installing roof aerial R216, saloon – Audi A6 C6 · 2 torque figures
• Removing and installing shift unit – Audi A8 D3
• Removing and installing injectors - vehicles with 2.8 ltr. engine · 1 torque figures
• Removing gearbox - vehicles with 6-cylinder 3.0 ltr. TDI engine