Removing and installing bracket for arrester: Audi A1
Step-by-step removing and installing bracket for arrester for the Audi A1: 3 steps, 1 torque figure. What to remove, what to tighten and to how many Nm.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A1 (8X, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 11 Nm (8.1 lb-ft) | Fit bracket on locating lugs (arrows) and tighten bolts |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Unclip coupling unit for Bowden cable at bracket (1).
- Remove bolts (2).
- Fit bracket on locating lugs (arrows) and tighten bolts to 11 Nm. — 11 Nm (8.1 lb-ft)
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing aluminium wheel bearing housing – Audi
- Removing and installing heated rear window shunt resistor N219 (Saloon) · 2 torque figures
- Removing and installing air conditioner compressor (manufacturer Denso or Zexel) · 2 torque figures
- Removing and installing engine bracket
- Emptying fuel tank, four-wheel drive, engine codes CFHC, CFHE, CFHF, CLCA, CLCB, CFJA
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.