Removing and installing Bowden cable for bonnet lock: Audi A4 B9
Step-by-step removing and installing Bowden cable for bonnet lock for the Audi A4 B9: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A4 B9 (8W, 2015–)
Don't miss
- Press housing cover (1) on so that arrow marking points in direction of free connection on coupling unit.
📋 Procedure
- Remove bracket for onboard supply control unit Electrical system97Relay carriers, fuse carriers, electronics boxes; Overview of fitting locations - relay carriers, fuse carriers, electronics boxes.
- Release Bowden cable (2) from support bracket (3) and disengage Bowden cable nipple (1).
- Remove plenum chamber cover .
- Release fasteners (arrows) and detach housing cover (1).
- Release Bowden cable (4) from support bracket (3) and disengage Bowden cable nipple (2).
- Move Bowden cable clear at lock carrier and at body.
- Detach grommet and pull Bowden cable out towards outside.
- Engage Bowden cable nipple (3) in roller of coupling unit (2) and press Bowden cable into support bracket.
- Press housing cover (1) on so that arrow marking points in direction of free connection on coupling unit.
- Adjust Bowden cable using knurled wheel so that bonnet locks are released simultaneously.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing toothed belt, vehicles 01.06 ►
- Installing gearbox, four-wheel drive
- Installing gearbox, vehicles with all-wheel drive as of model year 2010
- Removing and installing coolant pipe (right-side) – Audi · 1 torque figures
- Installing gearbox - vehicles with 1.9 ltr. TDI engine – Audi
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.