Removing and installing bonnet lock and Bowden cable — AUDI

🧭 Before you start

Fits: platform codes S1, 2H

Don't miss

• Attachment plate (3) sits between lock support and lock carrier.

📋 Procedure

1. Open bonnet.
2. Detach Bowden cable at Bowden cable coupling .
3. Unclip Bowden cable (4) from lock carrier.
4. Separate electrical connector (5) for bonnet contact switch.
5. Remove bolts (2) from lock carrier.

6. Withdraw lid lock (1) with attachment plate (3) (if fitted) upwards.
7. Unclip Bowden cable (4) from lid lock (1).
8. Insert lid lock (1) with attachment plate (3) (if fitted) into lock carrier. [Note: Attachment plate (3) sits between lock support and lock carrier.]
9. Reconnect electrical connector (5) for bonnet contact switch.
10. Attach Bowden cable to Bowden cable coupling .
11. Clip in Bowden cable (4) on lock carrier.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing rear DVD changer R162 – Audi A8 D3 · 2 torque figures
• Vehicles with 3.0 ltr. TDI engine - alternator with water cooling
• Removing and installing drive shaft with 107 mm ∅ outer constant velocity joint and 112 mm ∅ inner constant velocity joint · 1 torque figures
• Removing and installing partition glass
• Removing and installing wheel bearing housing (front-wheel drive)