Removing and installing backrest centre section: Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the left and right individual rear seats .
2. Remove the filler piece .
3. Remove the rear shelf trim .
4. Unscrew the nuts (2) (4x). Tightening torque 8 Nm. — 8 Nm (5.9 lb-ft)
5. Take out the backrest centre section (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing poly V-belts – Audi · 2 torque figures
• Checking charge pressure control solenoid valve N75 – Audi
• Checking secondary air inlet valve N112 – Audi TT Mk1
• Removing and installing sealing flange (pulley end) – Audi
• Checking secondary air pump relay J299 or J316 and activation