Removing and installing 2/3 section of backrest (right-side) — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

Don't miss

• On vehicles with backrest heating make sure connector for backrest heating is fitted in correct installation position .
• Make sure that backrest engages .

📋 Procedure

1. On vehicles with ski bag remove ski bag .
2. Remove centre belt end fitting .
3. Fold 1/3 section of backrest (left-side) and 2/3 section of backrest (right-side) down.
4. Remove cover and clamp from centre bracket (3).
5. Lift backrest (6) out of centre bracket (3) in direction of (arrow A) and detach backrest from fitting (1) in direction of (arrow B).

6. Re-fit grommet (2) if it is pulled out when removing backrest.
7. On vehicles with backrest heating unplug connector for backrest heating (4).
8. On vehicles with belt tensioner unplug connector for belt tensioner (5).
9. On vehicles with backrest heating make sure connector for backrest heating is fitted in correct installation position .
10. Make sure that backrest engages .
11. Unscrew bolt (1).
12. Push anchorage point (4) out in direction of arrow.
13. Install binding clip (2) at side padding (1).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing toothed belt, engine code AHH
• Removing and installing toothed belt assembly > 07.91 – Audi
• Testing wiring between gearbox and 68-pin connector on gearbox control unit
• Adjusting CO2-content in additional heater exhaust gas
• Removing and installing prop shaft