Removing and installing attachments - TT RS — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Spoiler and trim (bottom) must engage fully.
• Diffuser trim must engage fully.

📋 Procedure

1. Remove diffuser trim .
2. Unscrew bolts (4) (left and right).
3. Remove bolts (1) and (2) from trim (bottom).
4. Pull trim (bottom) (3) off bumper (rear) (arrows).
5. Pull spoiler (2) off trim (bottom) (1)(arrows).

6. Spoiler and trim (bottom) must engage fully.
7. Install diffuser trim .
8. Remove bolts (1) and (3).
9. Pull off diffuser trim (2)(arrows).
10. Diffuser trim must engage fully.
11. Remove bumper (rear) .
12. Remove bolts (arrows).
13. Detach exhaust trim (1) inwards from bumper cover.
14. Check distance between exhaust trim (2) and bumper cover (1):
15. Install bumper (rear) .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Servicing subframe - front-wheel drive vehicles
• Checking heating output and activation of temperature flaps - deluxe version
• Removing and installing refrigerant lines with internal heat exchanger - RS models
• Removing and installing refrigerant lines with internal heat exchanger - Audi Q5 hybrid
• Removing and installing brake pads for ceramic brakes (1LW) · 1 torque figures