Removing and installing air intake unit — AUDI

🧭 Before you start

Fits: platform code 42

📋 Procedure

1. Switch off the ignition.
2. Remove the luggage compartment pan 70.
3. Unplug the connectors (D).
4. Screw out the bolts (B).
5. Remove the air intake unit (C).

6. Check the seal (A) for damage and proper installation in the air intake unit (B).
7. Check the socket (A) for damage and correct installation at the air conditioning unit and in the back wall of the plenum chamber.
8. Check the water drain (E) for damage and contamination and clean if necessary .
9. Position the air intake unit (C) at the back wall of the plenum chamber.
10. Tighten the bolts (B).
11. Install the luggage compartment pan 70.
12. Interrogate the event recorder and erase any faults displayed.
13. Implement basic setting.
14. Implement final control diagnosis.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing storage compartment/knee bolster (driver's side)
• Removing and installing small storage compartment – Audi A8 D3 · 1 torque figures
• Removing and installing intermediate piece for air duct – Audi · 1 torque figures
• Removing and installing centre head restraint blind – Audi
• Removing and installing individual rear seat – Audi A8 D3