Removing and installing individual rear seat: Audi A8 D3

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

Don't miss

• Make sure the individual rear seat (3) engages on the left and right at the sliders in the guides in the body.

📋 Procedure

1. Remove the seat pan .
2. Unplug the connectors (7), (8), (9) and (10).
3. Detach the wiring harness (13) from the body.
4. Raise the tab (11) and unscrew the bolt (12).
5. Raise the tab (14) and unscrew the bolt (15).

6. Pull the tab (2) aside and unscrew the bolt (1).
7. Open the webbing guide (5) at the clip (6).
8. Thread the webbing (4) out of the guide (5).
9. Unscrew the bolt at the anchorage point of the webbing (4).
10. Pull the seat frame forwards until the backrest slides out of its guide.
11. Lift the individual rear seat (3) out of the vehicle.
12. Install the individual rear seat (3) in the reverse order of removal.
13. Make sure the individual rear seat (3) engages on the left and right at the sliders in the guides in the body.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing turbocharger 1 control unit J724 - vehicles with two turbochargers, manual mode
• Removing glove box
• Adjusting wiper arms – Audi A4 B5
• Renewing bulb for dipped beam headlights – Audi
• Removing and installing lock cylinder – Audi A4 B5