Removing and installing aerial amplifier R24 (from week 36/08 onwards) — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove roof end trim General body repairs, interior70.
4. Unplug connectors for aerial wires (3) and (4).
5. Unscrew earth connection (2) (9 Nm). — 9 Nm (6.6 lb-ft)
6. Release retainers (arrows) on both sides and remove the aerial amplifier R24(1).
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing steering wheel up to 08.97 – Audi · 1 torque figures
• Removing and installing track rod ball joints – Audi TT Mk1 · 1 torque figures
• Removing and installing steering lock with ignition/starter switch (without lock cylinder) · 1 torque figures
• Removing and installing driver's airbag unit with standard steering wheel · 1 torque figures
• Removing and installing telephone transmitter and receiver unit R36 (Saloon, from MY 00) · 1 torque figures