Removing and installing aerial amplifier R24, Avant (up to week 35/08) — AUDI

🧭 Before you start

Fits: Audi A6 C6 (4F, 2004–2011)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Switch off all electrical equipment.
2. Remove ignition key.
3. Remove luggage compartment side trim (left-side) General body repairs, interior70.
4. Unplug all connectors on aerial amplifier R24(1).
5. Unscrew bolts (2) (2 Nm) at aerial amplifier R24(1). — 2 Nm (1.5 lb-ft)
6. Detach aerial amplifier R24(1).
7. Installation is performed in reverse sequence.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing bonded rubber bushes in subframe – Audi A6 C6
• Removing and installing fuel tank with attached components, all except USA vehicles
• Separating engine and gearbox - vehicles with engine codes CTBA, CTBC and dual clutch gearbox · 2 torque figures
• Oil pump, sump (bottom section), sump (top section) - exploded view · 4 torque figures
• Removing and installing internal loudspeaker R70 – Audi · 4 torque figures