Removing and installing digital radio aerial R183 (up to week 35/08)/aerial amplifier 3R112 (from week 36/08 onwards), saloon — AUDI
Removing and installing digital radio aerial R183 (up to week 35/08)/aerial amplifier 3R112 (from week 36/08 onwards), saloon on Audi: 6 steps, 1 torque.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C6 (4F, 2004–2011)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Unscrew bolt (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove D-pillar trim (left-side) General body repairs, interior70.
- Unplug connector (2) at digital radio aerial R183(1).
- Unscrew bolt (3) (2 Nm) and detach digital radio aerial R183(1) from D-pillar. — 2 Nm (1.5 lb-ft)
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Renewing balancer shaft for inlet camshaft
- Removing and installing camshaft timing chain, ►29-04-2013
- Removing and installing drive shaft, right drive shaft · 1 torque figures
- Removing front left and front right hinges for pop-up roof, scenario 1
- Removing and installing starter, vehicles with 5-cylinder diesel engine · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.