Removing and installing aerial amplifier, mobile telephone R86 — AUDI
Removing and installing aerial amplifier, mobile telephone R86 on Audi: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A2 (8Z)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Turn rear side to front and screw out bolts (3) of amplifier (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical equipment.
- Remove ignition key.
- Remove right luggage compartment side trim General body repairs, interior70.
- Unplug connector.
- Screw out the three bolts (arrows) of the holder mount (1).
- Turn rear side to front and screw out bolts (3) of amplifier (2) (2 Nm). — 2 Nm (1.5 lb-ft)
- Install accordingly in reverse order of removal.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing camshaft toothed belt
- Checking lambda probe heating for lambda probes upstream or downstream of catalytic converter
- Layout of front axle components
- Servicing self-levelling suspension - (V6-petrol engine)
- Checking operation of remote control and auxiliary heating radio wave receiver -R64
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.