Removing and installing 3-position relay carrier in plenum chamber electronics box — AUDI
Removing and installing 3-position relay carrier in plenum chamber electronics box on Audi: 11 steps.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C5 (4B)
Don't miss
- (Arrows) can be ignored.
- Precise assignment of 3-position relay carrier in plenum chamber electronics box can be seen from applicable current flow diagram .
📋 Procedure
- Remove the wiper arms .
- ⚠ To stop the cowl panel grille (1) being torn on removal, apply a small quantity of soap solution to the transition between the windscreen and cowl panel grille and pull the cowl panel grille vertically upwards out of the fastening strip, starting at the edge of the windscreen. — Detach the clips (arrows) and remove the cowl panel grille (1).
- With ignition switched off, disconnect earth wire at battery:
- Screw out bolts (arrows).
- Take out cover for electronics box in plenum chamber.
- Use screwdriver to carefully prise off fastener (arrow).
- Lay aside engine control unit with connectors (1) and (2) connected. [Note: (Arrows) can be ignored.]
- Release catch (arrow) and lift off 3-position relay carrier in electronics box.
- Pull out relays or control units and then unclip corresponding plug-in socket for multi-pin connectors. [Note: Precise assignment of 3-position relay carrier in plenum chamber electronics box can be seen from applicable current flow diagram .]
- Connect battery. Action to be taken:
- Adjust the wiper arms .
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing water radiator for fuel cooling system - vehicles with engine code letters AJM
- Dismantling and assembling input shaft - gearboxes from approx. 04.2003
- Checking air conditioner compressor shutoff – Audi TT Mk1 1.8
- Removing and installing telephone aerial R65 (glass roof panel)
- Removing and installing operating electronics control unit, navigation J402
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.