Rear sealing flange and dual-mass flywheel - exploded view — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 67 workshop diagrams for AXX

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Screw in bolts (1 ... 8) hand-tight.
2. Tighten bolts (1 ... 6) in diagonal sequence and in stages to 15 Nm. — 15 Nm (11 lb-ft)
3. Tighten bolts (7 ... 8) to 15 Nm. — 15 Nm (11 lb-ft)
4. Fit intermediate plate on sealing flange and push onto dowel sleeves (arrows).

Other AUDI procedures

• Adapting kick-down function - vehicles with automatic gearbox or dual clutch gearbox
• Checking oil pressure and oil pressure switch (2-pin oil pressure switch)
• Checking oil pressure and oil pressure switch (single pin oil pressure switch)
• Removing and installing cowling with radiator fan V7 and radiator fan 2V177
• Installing and adjusting balancer shaft gear assembly with oil pump
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures