Performing kick-down adaption - vehicles with automatic gearbox — AUDI

🧭 Before you start

Fits: Audi A3 (8L, 1996–2003)

🔧 Engine codes this applies to

📋 Procedure

1. Switch on ignition.
2. Select Vehicle self-diagnosis from the list (item 1).
3. From menu (1), select vehicle system "“Engine electronics”" and press → key to continue.
4. From menu (1), select diagnosis function "“Basic setting”" and press → key to continue.
5. Press keys 63 on keypad (1) to select "“Display group 063”" and confirm entry by pressing Q key.

6. Check display in display zones (3) and (4).
7. Fully depress accelerator pedal beyond kickdown point and keep it pressed. [Note: If the display shows "“Kickdown ERROR”": interrogate fault memory."“ERROR”" is indicated, for example, if the accelerator pedal is not pressed immediately after requested by the tester or if the accelerator pedal is released before the adaption process is finished. Exit function "“Basic setting”" by pressing ← key and restart adaption.]
8. Press ← key to terminate function "“Basic setting”".
9. From menu (1), select function "“End output”" and press → key to continue.
10. Switch off ignition and unplug diagnostic connector.

Other AUDI procedures

• Removing and installing parts of the injection system
• Removing and installing parts of the lubrication system
• Removing and installing parts of exhaust system
• Removing and installing poly-V-belt – VW Golf IV / Bora 1.6
• Testing lambda probe signal wiring and activation
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures