Fitting location of remote control receiver for auxiliary/supplementary heater — AUDI

Fitting location of remote control receiver for auxiliary/supplementary heater
Note
A remote control for the auxiliary heater is currently only available for vehicles without high-voltage system, and not for vehicles with high-voltage system (Audi A3 e-tron). As an optional extra on vehicles with high-voltage system, the auxiliary heater / auxiliary ventilation can be switched on and off using
“Audi connect services”
(via a mobile phone and
control unit 1 for information electronics
J794
) rather than a remote control
Communication
Rep. gr.
91
Telephone system; Layout - telephone
,
Current flow diagrams, Electrical fault finding and Fitting locations
,
Owner's Manual
and
Infotainment/MMI Operating Manual
.
Currently only the version as an auxiliary heater is available. At the moment the auxiliary heater is not intended to be operated as a supplementary heater. On vehicles with a diesel engine (without high-voltage system), the supplementary heating function is provided by the
auxiliary air heater element
Z35
Heating, air conditioning
Rep. gr.
87
Heater and air conditioning unit (front); Exploded view - heater and air conditioning unit
.
A
high-voltage heater (PTC)
Z115
is fitted on vehicles with high-voltage system.
Z115
is activated by the air conditioner operating unit
J255
if additional heat output is required to attain the specified temperature in the passenger compartment
Heating, air conditioning
Rep. gr.
00
Repair instructions
,
Owner's Manual
and
Infotainment/MMI Operating Manual
.
The remote control receiver
1
is installed in the control unit mounting in the luggage compartment (right-side as seen in direction of travel) beneath the trim in the area behind the wheel housing liner.
For access to
remote control receiver for auxiliary heater
R64
, remove luggage compartment trim
General body repairs, interior
Rep. gr.
70
Luggage compartment trim panels
(Removing and installing luggage compartment side trim).
The hand-held remote control transmitters are adapted in the
remote control receiver for auxiliary heater
R64
. If this is renewed, all remote controls must be re-adapted
Vehicle diagnostic tester
in
“Guided Fault Finding”
mode.
Note
There are different versions of the hand-held remote control transmitter and the
remote control receiver for auxiliary heater
R64
. Therefore you must make sure that the remote control is correctly assigned and that the auxiliary heater is coded correctly
Electronic parts catalogue
,
Chapter
“
Allocation of hand-held transmitter and remote control receiver for auxiliary/supplementary heater
”
and
Vehicle diagnostic tester
in
“Guided Fault Finding”
mode (the auxiliary heater will not function if the assignment is not correct).