Exploded view - sump (bottom section) and oil pump — AUDI
Exploded view - sump (bottom section) and oil pump on Audi: 5 steps, 2 torque figures, engines CCWA, CCWB.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi Q5 (8R, 2008–2017)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 5 Nm (3.7 lb-ft) | Initially tighten |
| 8 Nm (5.9 lb-ft) | Tighten |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tighten bolts in 3 stages and in diagonal sequence as follows:
- Initially tighten to 5 Nm. — 5 Nm (3.7 lb-ft)
- Tighten to 8 Nm. — 8 Nm (5.9 lb-ft)
- Turn 90° further.
- Connect electrical connector (1) for oil level and oil temperature sender G266.
Other AUDI procedures
- Removing and installing turbocharger 1 control unit J724 · 4 torque figures
- Removing and installing toothed belt for high-pressure pump · 3 torque figures
- Removing engine - vehicles with automatic gearbox 0B6 · 1 torque figures
- Measuring radial clearance of camshaft – Audi A6/A7 C7 · 6 torque figures
- Separating engine and gearbox - manual gearbox · 3 torque figures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.