Exploded view of "„K2/K3“" clutch housing — AUDI

🧭 Before you start

Fits: Audi A3 (8L, 1996–2003)

📋 Procedure

1. Slowly and carefully press down piston cap just far enough so that the circlip can be removed.
2. Remove circlip.
3. Remove piston cap and spring.
4. Drive the two nesting pistons out of clutch housing.
5. To do this, gently strike the upper edge of the clutch housing with a plastic hammer.

6. Carefully press "„K2“" piston by hand into clutch housing as far as stop.
7. Carefully press "„K3“" piston by hand into "„K2“" as far as stop.
8. Fit spring, piston cap and circlip in clutch housing.
9. Carefully centre piston cap before pressing it down.
10. Slowly and carefully press down piston cap just far enough so that circlip can be installed.
11. Fit circlip.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• 2.7/3.0TDi (CGKA,CGKB,CCWA, CCLA)
• Detaching refrigerant lines from condenser/re-attaching · 1 torque figures
• General body repairs, exterior — Central locking system · 1 torque figures
• Detaching and attaching air conditioner compressor at bracket, vehicles with 4-cyl. or 6-cyl. engine · 1 torque figures
• Detaching and attaching air conditioner compressor at bracket (mechanically driven air conditioner compressor) - vehicles with 4-cyl. engine · 1 torque figures