Camshaft housing - exploded view — AUDI

🧭 Before you start

Fits: Audi A2 (8Z)

• Renewed: camshaft housing bolts

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 44 workshop diagrams for AUA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Renew camshaft housing bolts.
2. Tighten bolts in the sequence (1 ... 15) in 2 stages as follows:
3. Tighten to 10 Nm. — 10 Nm (7.4 lb-ft)
4. Turn 90° further.

Other AUDI procedures

• Checking electronic power control (EPC)
• Dismantling and assembling air cleaner
• Connecting fault reader V.A.G 1551 and selecting engine control unit
• Checking engine operating mode
• Checking ignition transformer – Audi AUA/BAH
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures