Exploded view - cylinder head cover — AUDI
Exploded view - cylinder head cover on Audi: 3 steps, 1 torque figure, engines CAGA, CAGB, CAGC, CAHA.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A5 Cabriolet (8F), Audi A5 (8T, 2007–2016), Audi A4 B8 (8K, 2007–2015)
- Special tools named: torque wrench
Don't miss
- Take care to keep cylinder head cover straight.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Tighten bolts in the sequence |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Loosen bolts in the sequence (7 ... 1).
- Fit bolts in the sequence (1 ... 7) and hand-tighten in several stages.
- Tighten bolts in the sequence (1 ... 7) to 10 Nm using torque wrench. [Note: Take care to keep cylinder head cover straight.] — 10 Nm (7.4 lb-ft)
Other AUDI procedures
- Removing and installing vacuum unit for exhaust gas recirculation cooler
- Filling and bleeding fuel system
- Checking delivery rate of fuel pump G6 - 4-cylinder and 6-cylinder engines (generation I)
- Removing and installing exhaust gas pressure sensor 1G450
- Removing and installing misfuelling prevention device – Audi
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.