Converting adapter10 - 222 A /23 with adapter10 - 222 A /23-1 — AUDI

🧭 Before you start

Fits: VW Transporter T6 (7F), VW Transporter T6 (7E)

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 31 workshop diagrams for CAAA

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove cap (1).
2. Remove cap (2) and unscrew underlying support bolt (3).
3. Insert adapter10 - 222 A /23-1(4) into adapter10 - 222 A /23(5).
4. Insert bolt (6) into adapter10 - 222 A /23 from below and tighten to 40 Nm. — 40 Nm (30 lb-ft)

Other AUDI procedures

• Removing and installing turbocharger, "“single turbo engine”", vehicles with four-wheel drive
• Draining and filling coolant
• Removing and installing ancillary bracket – Audi 2.0 TDI · 1 torque figures
• Testing injectors – Audi 2.0 TDI
• Assembly overview - sump/oil pump, vehicles with balancer shaft module · 3 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures