Connecting airbag adapterVAS 5094 — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Special tools named: VAS 5094

📋 Procedure

1. Disconnect igniter and earth wires from side airbag .
2. Plug connector (2) (airbag adapter VAS 5094) into connector housing (3).
3. Connect igniter wire (6) from airbag unit to connector (1) (airbag adapter).
4. Disconnect igniter and earth wires from side airbag .
5. Connect igniter wire of airbag unit to connector (5) (airbag adapter).

6. ⚠ Leave airbag adapter VAS 5094 connected to seat until seat has been re-installed. — Use screwdriver (4) to lever connector (1) for side airbag over retaining tab (2) and unplug connector in direction of arrow (3).
7. If it is not possible to lever out connector for side airbag using a screwdriver, press retaining tab of connector to side with one finger (5).
8. At the same time, pull connector for side airbag towards the front with the other hand.
9. Using a screwdriver (1), lever catch (2) over retaining tab (3) and unplug connector (4).
10. Press retaining tab (2) and pull out connector in direction of arrow.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing rear ISOFIX holder with electrically operated individual seats · 2 torque figures
• Removing and installing selector mechanism - vehicles from 05.99 onwards, vehicle ID No. 4B-X-130 001 ►
• Removing and installing radio/telephone rod aerial - Roadster (as of MY 01) · 2 torque figures
• Removing and installing navigation aerial (GPS)R50 – Audi · 2 torque figures
• Removing and installing telephone/telematics control unit J526 (telephone operation only) · 2 torque figures