Removing and installing rear ISOFIX holder with electrically operated individual seats — AUDI

🧭 Before you start

Fits: Audi A8 D3 (4E, 2002–2010)

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove the seat pan .
2. Unscrew the bolt (2). 40 Nm. — 40 Nm (30 lb-ft)
3. Unscrew the bolt (3). 55 Nm. — 55 Nm (41 lb-ft)
4. Take out the ISOFIX holder (4).
5. Unscrew the bolt (2). 40 Nm. — 40 Nm (30 lb-ft)

6. Unscrew the bolt (3). 55 Nm. — 55 Nm (41 lb-ft)
7. Slacken off the front inner bolt of the electrically operated individual seats by a few turns.
8. Pull out the ISOFIX holder (1) beneath the electrically operated individual seat.
9. On installation, slide the ISOFIX holder (1) beneath the electrically operated individual seat.
10. The electrically operated individual seat and ISOFIX holder (1) are screwed together using the bolt (3).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking actuation of seat heating (optional extra)
• Replacing air conditioner compressor pulley (“Denso” make, version “2”)
• Checking operation of air recirculation flap control motor V113
• Removing and installing fresh air blower control unit J126 and fresh air blower V2
• Exploded view - air supply unit and solenoid valve block