Removing and installing radio/telephone rod aerial - Roadster (as of MY 01) — AUDI
Removing and installing radio/telephone rod aerial - Roadster (as of MY 01) on Audi: 10 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 5 Nm (3.7 lb-ft) | Screw out bolt (3 |
| 9 Nm (6.6 lb-ft) | Unscrew nut (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Switch off all electrical consumers.
- Remove ignition key.
- Remove left luggage compartment side trim: General Body Assembly, Interior70.
- Unscrew the rod aerial.
- Detach the aerial sleeve (1).
- Unscrew nut (2) (9 Nm). — 9 Nm (6.6 lb-ft)
- Unplug aerial wire.
- Screw out bolt (3) (5 Nm). — 5 Nm (3.7 lb-ft)
- Pull out aerial (4) inwards.
- Installation is performed in reverse sequence.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing humidity sender G355 - vehicles with main beam assist
- Removing and installing alarm horn H12 – Audi A8 D4
- Removing and installing relay carrier underneath dash panel (left-side)
- Removing and installing mounting for relay carrier underneath dash panel (left-side), onboard supply control unit J519
- Removing and installing 8-inch display with kinematic display carrier
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.