Coding pocket sender — AUDI

🧭 Before you start

Fits: platform codes 2DA, 2DB, 2DC, 2DD, 2DE, 2DF, 2DG, 2DH, 2DK, 2DL, 2DM

📋 Procedure

1. Push down locks (2).
2. Open additional relay carrier (1).
3. Remove control unit for radio remote control from seat box.
4. Turn switch number 2 (2) on control unit (1) to position "“ON”" in (direction of arrow).
5. Press both buttons (4 and 5) of pocket sender (3) (for at least 10 seconds) until flashing LED goes out.

6. Release buttons of pocket sender. LED now stays on.
7. Press button (4), LED goes out.
8. Repeat work steps using second pocket sender.
9. Turn switch number 2 (2) on control unit (1) to position "“OFF”" against (direction of arrow).
10. Carry out functional check on both pocket senders.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Checking oil level for Haldex coupling, Haldex generation IV
• Checking oil level for Haldex coupling, Haldex generation V
• Removing and installing manual release cable for tank flap
• Removing and installing microswitch for lowering window E621/E622
• Removing and installing hydraulic fluid reservoir