Checking delivery pressure of power steering pump - vehicles with 8-cyl. petrol engine — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Renewed: power steering pump

📋 Procedure

1. Detach the cover from the reservoir.
2. Clamp off suction pipe with hose clamp3094.
3. Unscrew the expansion hose from the power steering pump.
4. Screw the adapterV.A.G 1402/3 into the power steering pump in place of the banjo bolt.
5. Screw the hose of the pressure gaugeV.A.G 1402 onto the adapterV.A.G 1402/3.

6. Close cut-off valve on pressure gauge (lever pointing to the left).
7. Detach the hose clamps3094 and top up the fluid level in the reservoir if necessary.
8. Renew power steering pump if specification is not attained .
9. Switch off engine.
10. Check hydraulic fluid level .
11. Bleed steering system .
12. Checking steering system for leaks

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing fuel filter, vehicles without supplementary fuel pump V393
• Removing and installing rear three-point seat belt, Kombi
• Removing and installing luggage compartment side trim, Multivan, rear, side of vehicle with sliding door
• Removing and installing operating mechanism, with mechanical locking system
• Removing undamaged double cab side window