Checking delivery pressure of power steering pump - vehicles with 6-cyl. petrol engine, biturbo — AUDI

🧭 Before you start

Fits: Audi A6 C5 (4B)

• Renewed: power steering pump

📋 Procedure

1. Unfasten the hose clamps (arrows) and take out the intake hose (1).
2. Unscrew union nut (2) whilst providing support at hexagon of pressure pipe.
3. Close off the pipe leading to the steering rack with a blanking plug.
4. Screw the adapterV.A.G 1402/3 into the pipe to the power steering pump.
5. Screw the hose of the pressure gaugeV.A.G 1402 onto the adapterV.A.G 1402/3.

6. Close cut-off valve on pressure gauge (lever pointing to the left).
7. Re-install intake hose.
8. Top up fluid in reservoir if necessary.
9. Renew power steering pump if specification is not attained .
10. Switch off engine.
11. Check hydraulic fluid level .
12. Bleed steering system .
13. Checking steering system for leaks

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Renewing 12 V socket U5
• Removing and installing three-point seat belt (front) - vehicles with 3 doors
• Renewing oil seal (left-side) - manual gearbox 0DF – Audi A1
• Removing and installing mounting bracket, Audi A1 quattro
• Renewing needle bearings and flange shaft oil seal (right-side)