Assembly overview - cylinder block, gearbox end — AUDI
Assembly overview - cylinder block, gearbox end on Audi: 5 steps, 1 torque figure, engines CAAA, CAAB, CAAC, CAAD.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Transporter T6 (7F), VW Transporter T6 (7E)
- Renewed: bolts for sealing flange
🔧 Engine codes this applies to
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 15 Nm (11 lb-ft) | In diagonal sequence and in stages |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Attach cover to sealing flange (arrow at top) and push onto dowel pins (arrows at bottom).
- Renew bolts for sealing flange on gearbox side.
- Tighten bolts in sequence (1 … 6) in 2 stages as follows:
- Screw in as far as stop by hand.
- In diagonal sequence and in stages; final torque 15 Nm — 15 Nm (11 lb-ft)
Other AUDI procedures
- Removing and installing vacuum pump – Audi A8 D3 · 2 torque figures
- Removing and installing flywheel · 3 torque figures
- Removing and installing turbocharger, "“single turbo engine”", vehicles with four-wheel drive
- Draining and filling coolant
- Removing and installing ancillary bracket – Audi 2.0 TDI · 1 torque figures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.