Assembling body "“I”" — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H), Audi A4 B5 (8D), Audi A4 B6/B7 (8E), Audi A6 C5 (4B), Audi A8 D2 (4D)

Don't miss

• Make sure that lifting tool is securely attached in body "“I”".

📋 Procedure

1. Place planetary drive "“III”"(item 1) into support element T10282.
2. Fit thrust washer (2), axial needle bearing (3) and flange washer (4) on planetary drive "“III”"(item 1).
3. Fit clutch "“F”"(item 5) onto plate carrier of planetary drive "“III”"(item 1) (lift and rotate clutch slightly as required).
4. Lift clutch "“F”" a few millimetres and then let it drop to check that the plates have meshed.
5. Fit clutch "“D/G”"(item 2) onto plate carrier of clutch "“F”"(item 1) (lift and rotate slightly as required).

6. Lift clutch "“D/G”" a few millimetres and then let it drop to check whether the plates have meshed.
7. Unscrew knurled nut on lifting tool slightly.
8. Insert lifting tool into body "“I”" far as it will go.
9. Tighten knurled nut on lifting tool by turning clockwise.
10. Make sure that lifting tool is securely attached in body "“I”".

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures