Automatic gearbox 09G — Exploded view - ATF oil pan, ATF strainer, valve body and internal wiring harnesses — AUDI
Automatic gearbox 09G — Exploded view - ATF oil pan, ATF strainer, valve body and internal wiring harnesses on Audi: 5 steps, 2 torque figures.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi TT Mk1 (8N)
Don't miss
- Do not run engine or tow vehicle with ATF oil pan removed or when there is no ATF in the gearbox. — Tighten bolts for ATF oil pan diagonally in stages to 7 Nm.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 7 Nm (5.2 lb-ft) | ⚠ Do not run engine or tow vehicle with ATF oil pan removed or when there is no ATF in… |
| 8 Nm (5.9 lb-ft) | Tighten |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Do not run engine or tow vehicle with ATF oil pan removed or when there is no ATF in the gearbox. — Tighten bolts for ATF oil pan diagonally in stages to 7 Nm. — 7 Nm (5.2 lb-ft)
- Renew bolts (arrows) for valve body; note bolt lengths:
- Tighten bolts (arrows) in two stages from outside to inside as follows:
- Tighten to 8 Nm. — 8 Nm (5.9 lb-ft)
- Turn 90° further.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Adjusting gear selector mechanism
- Servicing cover for Torsen differential, removing and installing Torsen differential
- Removing and installing differential without differential lock
- Removing and installing gear selector mechanism
- Checking main pressure
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.