VW BER — 2L Engine
2L · 114 hp
Engine overview
Torque figures by job
From the step-by-step procedures for this engine — each figure sits in the step that uses it.
- 25 Nm (18 lb-ft) — Install the crankshaft pulley/vibration absorber
- 45 Nm (33 lb-ft) — Install engine support in the cylinder block
- 25 Nm (18 lb-ft) — Install Poly-V belt tensioning element
- 40 Nm (30 lb-ft) — When installing, position the double repair clamp (4) on the side markings (arrows 1 and…
Engine codes in the same family
The same code prefix usually means the same block with a different output, fuel or model year. Procedures are often shared — check the code on the engine plate.
Workshop procedures for this engine
Step-by-step procedures from the workshop database, carrying 27 torque figures.
- Checking process – VW Fox · 3 torque figures
- Installation · 20 torque figures
- Checking sequence · 1 torque figures
- Camshaft - repair
- Checking conditions – VW 2.0
- Cylinder head - assembly and disassembly
- Crankshaft - remove and install
- Removing and installing sealing flanges and flywheel/drive plate
- Continuation · 3 torque figures
Got a BER problem? Ask for free.
Describe the symptoms — TorqFix replies with a diagnosis cited from verified workshop data.
Get free diagnosis →Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 14 Oct 2026.