Tailgate lock (►CP 122368) - remove and install — VW

🧭 Before you start

Fits: platform codes 5U8, 5U9, 5U2, 5U1

Don't miss

• Pay attention to the rubber wedge that presses the rod.
• The tailgate handle with cylinder cannot be activated when fixing the rod to the clip.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Unglue the tape.
2. Remove adhesive residue with the adhesive removerD 002 000 10. Rub the surface with a cloth until it is completely dry.
3. Heat up previously the adhesion area with the hot air blowerVAG 1416 to facilitate installation.
4. Remove the adhesive tape liner, position it and press the rims with the pressure roll3356.
5. Remove the tailgate upper frame .

6. Remove the rear lid lining General body repairs, interior70Lining / insulation.
7. Release the clip (7) that fastens the operating rod (5).
8. Remove the screws (4) (25 Nm). — 25 Nm (18 lb-ft)
9. Remove the lock (1) along with the operating rod (5).
10. Insert the operating rod (5) into the tailgate, along with the lock. [Note: Pay attention to the rubber wedge that presses the rod.]
11. Install the screws (4) (25 Nm). — 25 Nm (18 lb-ft)
12. Place the rod (5) onto clip (7) and lock it. [Note: The tailgate handle with cylinder cannot be activated when fixing the rod to the clip.]
13. Install the rear lid lining General body repairs, interior70Lining / insulation.
14. Install the tailgate upper frame .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures