Starter B (vehicles with 01M automatic transmission) - remove and install — VW

🧭 Before you start

Fits: platform codes 9B1, 9B3

📋 Procedure

1. Turn off the ignition, all the electrical devices, and remove the key from ignition.
2. Disconnect the BatteryA .
3. Remove the lower engine noise insulation General body repairs, exterior50Body - front part.
4. Remove the side noise insulation (left side) from the engine compartment by releasing the hex nut and detaching the fastening clips (arrows).
5. Remove the BatteryA.

6. Release the fastening screws (arrows) and remove the support for the BatteryA.
7. Disconnect the connector (1) and remove it from the support.
8. Disconnect terminal (2) from StarterB.
9. Remove the plastic cover and the positive cable (3) from the magnetic switch.
10. Remove the connectors and cable from he StarterBsupport.
11. Remove the StarterBsupport.
12. Remove upper hex screw (1).
13. Remove the lower hex screw (2) and remove the StarterB.
14. Tighten the fastening nuts and screws to the specified tightening torque .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing brake light switch, RHD vehicles – VW
• Removing and installing desiccant bag, Denso condenser – VW
• Disconnecting and connecting battery, vehicles with high-voltage system
• Removing and installing radiator, variant 1 and 2 radiators
• Removing and installing high-voltage cable for high-voltage heater (PTC)