Renewing inner seal: VW Tiguan I

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

Don't miss

• Bonding surface must be free of dust and grease.

📋 Procedure

1. Remove front glass panel .
2. Remove rear glass panel .
3. Pull inner seal (2) off assembly frame (1).
4. Remove existing adhesive residues using adhesive residue removerVAS 6349.
5. Bonding surface must be free of dust and grease.

6. Clean bonding surface completely using cleaning solutionD 009 401 04.
7. Wipe bonding surfaces of assembly frame with supplied primer tissue.
8. Place inner seal (2) with butt positioned on rear centre of roof cut-out, onto bonding surface of assembly frame (1).
9. Pull protective backing from adhesive tape of new inner seal section by section and press it on.
10. Sprain any excess length of inner seal evenly.
11. Press in inner seal evenly and all round twice using roller for door insulation foil3356.
12. Install rear glass panel .
13. Install front glass panel .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking Lambda probe and Lambda regulation before catalytic converter
• Renewing oil seals for flanged shafts
• Allocation gearbox - engine
• Camshaft mechanism - repair
• Removing and installing reversing camera R189