Removing undamaged rear window (Sedan) — VW

🧭 Before you start

• Special tools named: V.A.G 1474, V.A.G 1351/1, V.A.G 1654

Don't miss

• Awl must be guided as close as possible to the window.
• Pull external thread end inwards and secure tool V.A.G 1351/1 to counterhold.

📋 Procedure

1. Remove both C pillar upper trims General body repairs, interior70
2. Remove package holder trim Body - Internal assembly jobs70
3. Removing roof trim.
4. Pull off connections for heated rear window and press connecting tabs onto window.
5. Push awl (V.A.G 1474) through adhesive bead (use on side area of rear window). [Note: Awl must be guided as close as possible to the window.]

6. Pull a cutting thread end inwards (use pliers and gloves).
7. If the gap is too small guide cutting thread on outside and push under the window with a plastic wedge.
8. Fit cutting thread around the rear window as shown.
9. Pull external thread end inwards and secure tool V.A.G 1351/1 to counterhold.
10. Secure end of thread on winding device.
11. Place winding device V.A.G 1654 in "“Position I”".
12. Apply corresponding device and cut releasing the window (if necessary, use inversion roll to guide thread).
13. Press cutting thread against window glass with plastic wedge during cutting process, in order to have clearance at window flange.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing cylinder head (engine codes CBEA, CJAA)
• Direct injection and glow plug system with distributor pump as of 10.99 — Fault table
• Removing and installing power steering box (TRW) – VW Polo 9N
• Fault finding, Power transmission — Complaints regarding clutch and clutch mechanism
• Direct injection and glow plug system with distributor pump as of 05.99 — Fault table