TorqFix

Removing mechatronics: VW Golf IV / Bora

Step-by-step removing mechatronics for the VW Golf IV / Bora: 12 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

12 steps 1 torque figure

🧭 Before you start

Fits: VW Golf IV / Bora (1J)

  • Opens: engine oil

Don't miss

  • Then remove it from second clip (arrow II) and lay to side. Do not kink line.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

TorqueFastener / step
20 Nm (15 lb-ft)Insert new filter with shoulder downwards and tighten cover

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

  1. Drain oil.
  2. Install (A - drain plug) with new seal.
  3. Remove filter.
  4. Insert new filter with shoulder downwards and tighten cover to 20 Nm. — 20 Nm (15 lb-ft)
  5. Following repair work, it is not necessary to change filter again when filling oil.
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove both (covers).
  2. Carefully release connector with a screwdriver.
  3. Pull off connector.
  4. First pull line out of lower clip (arrow I).
  5. Then remove it from second clip (arrow II) and lay to side. Do not kink line.
  6. Remove (securing bolts) diagonally. Start with bolt (1).
  7. Remove mechatronics for direct shift gearbox J743.

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.