Removing line and bleeder from and installing on slave cylinder — VW

🧭 Before you start

Fits: VW Tiguan I (5N, 2007–2016)

• Opens: brake fluid, clutch fluid

Don't miss

• Clamping off the supply hose with the hose clamp3094 will cause a permanent deformation.However, this does not damage the supply hose.After removing the hose clamp3094, the supply hose must be returned to its original shape.

🔧 Engine codes this applies to

📐 34 workshop diagrams for BYD

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Disconnect battery Electrical system27Battery; Disconnecting and connecting battery.
2. Clamp off supply hose to clutch master cylinder using hose clamps, up to 25 mm in diameter3094. [Note: Clamping off the supply hose with the hose clamp3094 will cause a permanent deformation.However, this does not damage the supply hose.After removing the hose clamp3094, the supply hose must be returned to its original shape.]
3. Clamp off hose of pipe/hose assembly (A) to slave cylinder using hose clamp, up to 25 mm in diameter3094.
4. Lay a lint-free cloth under bleeder.
5. Pull out clip (arrow) for pipe/hose assembly or pipeline to stop.

6. Pull pipe/hose assembly or pipe out of clutch slave cylinder bleeder and seal.
7. Tie up pipe/hose assembly.
8. ⚠ Risk of contamination due to brake fluid spill.Do not operate clutch pedal after detaching pipe/hose assembly from bleeder connection on clutch slave cylinder. — To remove, release securing clip (2) with a screwdriver or pointed object and pull line (4) off bleeder (1).
9. To install, push line (4) with O-ring (3) onto connection of bleeder (1) until securing clip (2) engages audibly.
10. Test line by tugging on it.
11. To remove, release securing clip (2) with a screwdriver and pull bleeder (4) off slave cylinder (1).
12. Seal clutch slave cylinder (1) with a plug.
13. To install, check O-ring (3) on slave cylinder. Press bleeder onto slave cylinder connection until securing clip engages audibly.
14. Check by pulling on bleeder.
15. Bleed clutch system .

Other VW procedures

• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Checking fuel pressure sender G247 · 19 torque figures
• Removing and installing high-pressure pump – VW Passat B8 · 16 torque figures
• Removing and installing camshaft adjuster – VW Golf IV / Bora · 14 torque figures
• Removing and installing injectors – VW · 11 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing headlight range control motor, Valeo