Removing handle button with reversing camera from rear lid — VW

📋 Procedure

1. Switch off ignition and all electrical consumers and remove ignition key.
2. Remove both securing nuts (arrows).
3. Remove large metal cover (1) taking connected wiring length into consideration.
4. Release wiring retainer of connector (1) by pressing on button (2) and disconnect connector.
5. Release and disconnect both connectors (1) and (3).

6. Remove both securing nuts (arrows).
7. Remove small metal cover (1) taking wiring which passes through from rear lid into consideration.
8. Release and disconnect connector (1).
9. Release both side locking lugs (arrows). Remove handle button (2) together with reversing camera and camera wiring harness outwards out of rear lid.
10. After connection, reconnect connector (1) on wiring retainer (2) until it audibly engages.
11. After installation, clean reversing camera lens with a lint-free cloth.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Checking oil level and replenishing
• Checking and adjusting idling switch
• Dismantling and assembling rear final drive
• Servicing air conditioning and heating - engine compartment
• Checking modulating piston movement sender and quantity adjuster