Removing front wing — VW

🧭 Before you start

Fits: platform codes 612, 614

Don't miss

• An adhesive bead (3) has been applied in the area of the A-pillar on some models. This adhesive bead will be cut through by the cutting cord357 853 999 A.

📋 Procedure

1. Remove front wheel housing liner .
2. Remove side turn signal light Electrical system94Side turn signal lights.
3. In vehicles with insulation, first remove the insulation .
4. Release locking hooks (3) and clip (2).
5. Pull away lower end of cover (1) a little (arrow b) and then remove downwards (arrow a). [Note: An adhesive bead (3) has been applied in the area of the A-pillar on some models. This adhesive bead will be cut through by the cutting cord357 853 999 A.]

6. Remove A-pillar trim .
7. Remove front bumper .
8. Pull out foam between wing and longitudinal member .
9. Pull web plate insulation out of wheel housing .
10. Remove bolts (2).
11. Rear bolt (2) can be reached with bonnet closed. Mask off bonnet in this area to prevent damage.
12. If an adhesive bead is located in area (3) between wing and A-pillar, this will be cut through by the cutting cord357 853 999 A.
13. Remove wing (1) carefully.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing right trim on front passenger seat without height adjustment · 1 torque figures
• Removing and installing fire extinguisher holder – VW Jetta VI · 1 torque figures
• Removing and installing cover and padding for "“1/3”" bench seat
• Adjusting striker plate · 1 torque figures
• Removing and installing poly V-belt pulley on alternator, without freewheel · 1 torque figures