Removing and installing wiring harness for solenoid valves — VW

🧭 Before you start

Fits: platform codes 5C7, 5C1

• Opens: gearbox oil
• Renewed: o-ring

📋 Procedure

1. Drain ATF .
2. Remove sump .
3. Remove ATF strainer .
4. Remove valve body .
5. Pull off solenoid valve connector (2) from gearbox connector.

6. Unscrew bolt for 14-pin gearbox connector on gearbox housing exterior.
7. Pull connector and wiring harness outwards out of gearbox housing.
8. Renew O-ring on connector.
9. Moisten O-ring with ATF.
10. Push connector with new O-ring into gearbox to stop.
11. Tighten bolt for 14-pin gearbox connector.
12. Install valve body .
13. Install ATF strainer .
14. Install sump .
15. Fill with ATF; check ATF level and top up .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing easy-entry Bowden cable B
• Removing and installing lid lock - LHD vehicle
• Removing and installing tank flap unit – VW Jetta VI
• Removing and installing ignition key battery – VW
• Repairing clutch release mechanism – VW Polo 6C 2.0