Removing and installing washer fluid reservoir, vehicles without headlight washer system — VW
Removing and installing washer fluid reservoir, vehicles without headlight washer system on VW: 16 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)
📋 Procedure
- Switch off ignition.
- Remove ignition key, if inserted.
- Remove filler neck with connecting pipe .
- Remove front bumper cover General body repairs, exterior63Front bumper; Removing and installing bumper cover.
- Remove left headlight .
- Remove front left wheel housing liner General body repairs, exterior66Wheel housing liner; Assembly overview - front wheel housing liner.
- Place drip tray under washer fluid reservoir.
- Turn retaining clips on washer fluid lines (3) and (5) to release.
- Pull washer fluid lines off windscreen and rear window washer pump V59(4).
- Release and separate electrical connector (6) from windscreen and rear window washer pump V59(4).
- Release and separate electrical connector (2) on windscreen washer fluid level sender G33(1).
- Follow route of wiring harness and unclip from retainers on washer fluid reservoir.
- Remove bolt (1).
- Remove bolt (1).
- Unscrew nut (1) and remove washer fluid reservoir (2).
- If washer fluid reservoir is renewed, remove following components from old reservoir, and install them to the new reservoir: [Note: The connections at the pump and hoses are colour-coded to prevent incorrect connection of the washer fluid lines to the windscreen and rear window washer pump V59. The hose fittings must be connected to the correct colour-coded pump connections during installation.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing automatic distance control unit from and installing on retaining plate, variant 1
- Removing and installing seat occupied recognition sensor – VW
- Lowering rear axle, multi-link suspension, front-wheel drive, e-Golf
- Removing and installing coolant pipes, front coolant pipes
- Removing and installing spring, multi-link suspension, left spring
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.