Removing and installing voltage regulator, V6 TDI engine: VW Touareg II
Step-by-step removing and installing voltage regulator, V6 TDI engine for the VW Touareg II: 7 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4 Nm (3.0 lb-ft) | Install voltage regulator and tighten |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove alternator .
- Carefully lever out deflector cap (1).
- Remove bolts (2) and take out voltage regulator.
- Install voltage regulator and tighten to 4 Nm. — 4 Nm (3.0 lb-ft)
- Press down deflector cap for carbon brushes (A)(arrow) until is it flush with the voltage regulator housing.
- Fit new deflector cap of voltage regulator (1).
- Reinstall alternator.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing relay carrier
- Tension pulley of main indented belt - check
- Removing and installing alternator, 2.0 l, 103 kW TDI engine
- Removing and installing steering column switch base (manufacturer: Kostal) · 1 torque figures
- Removing and installing front interior light W1 – VW Phaeton · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.