Removing and installing upper trim for A-pillar — VW
Removing and installing upper trim for A-pillar on VW: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 137
- Renewed: if necessary
Don't miss
- Before installing, check fasteners for damage and renew if necessary.On reinstallation, airbag emblem must be renewed.
- Following installation, ensure that trim is positioned in door seal beading.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 2 Nm (1.5 lb-ft) | Remove airbag emblem (1) and remove bolt (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove side dash panel cover .
- Remove A-pillar middle trim
- Remove airbag emblem from trim.
- Position blade of a screwdriver before clip (1).
- Press screwdriver lightly in direction of sun visor (arrow A) and release trim from fasteners (arrow B).
- Pull A-pillar trim (1) out of mountings in dash panel. [Note: Before installing, check fasteners for damage and renew if necessary.On reinstallation, airbag emblem must be renewed.]
- Install in reverse order of removal. [Note: Following installation, ensure that trim is positioned in door seal beading.]
Other VW procedures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.