Removing and installing upper bulkhead trim panel: VW Golf Cabriolet

🧭 Before you start

Fits: VW Golf Cabriolet (517, 2011–2016)

• Renewed: if necessary

Don't miss

• During installation, the restraining strap (3) is to be placed in the recess.
• Before installing, check fasteners for damage and renew if necessary.

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📋 Procedure

1. Remove sill mouldings .
2. Remove belt anchor rail .
3. Remove bench seat .
4. Remove side trim .
5. Remove rear seat belt end anchors .

6. Remove stop buffer General body repairs, exterior;61Removing and installing stop buffer .
7. Unclip and remove roll-over bar covers (1) and (2) in the rear upwards (arrows). [Note: During installation, the restraining strap (3) is to be placed in the recess.]
8. Undo the 2 screws (1.5 Nm) above each roll-over bar. — 1.5 Nm (1.1 lb-ft)
9. Unclip and remove bulkhead trim panel (1) upwards.
10. On both sides, thread belt tongues and seat belt end anchors through the corresponding belt outlet opening. [Note: Before installing, check fasteners for damage and renew if necessary.]

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing wheel bearing unit, four-wheel drive
• Adjusting camber at front wheels – VW Passat B8
• Renewing panel seal – VW Polo 9N
• Installing side member extension – VW Touran I
• Removing roof spoiler