Removing and installing two-way signal amplifier for mobile telephone/data services J984 — VW

🧭 Before you start

Fits: VW Golf VII Variant (BA)

📋 Procedure

1. Switch off ignition and all electrical consumers.
2. Remove ignition key, if fitted.
3. Remove right luggage compartment side trim just enough so that the two-way signal amplifier for mobile telephone/data services J984 is accessible General body repairs, interior70Luggage compartment trims; Removing and installing luggage compartment side trim.
4. Cut any installed cable ties on retainer (3).
5. Press fasteners (2) and (5) in direction of arrows (A) and (B), respectively.

6. Remove two-way signal amplifier for mobile telephone/data services J984(1) from bracket.
7. Release and disconnect connector (4) on two-way signal amplifier for mobile telephone/data services J984(1).
8. Undo and remove bolts (2).
9. Remove bracket for two-way signal amplifier for mobile telephone/data services J984(1) from sidewall.
10. Release and detach any connectors on remote control receiver for auxiliary heater R64(3).
11. If necessary, remove remote control receiver for auxiliary heater R64 from bracket for two-way signal amplifier for mobile telephone/data services J984.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing oil seals for front right flange shaft and front right bevel gear with stub shaft
• Rear axle - Assembly overview
• Front axle in unladen position
• Repairing injection pump
• Cylinder head - disassemble and assemble