Removing and installing turn signal repeater bulb — VW
Removing and installing turn signal repeater bulb on VW: 8 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9C1, 1C1, 1Y7
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1 Nm (0.7 lb-ft) | Clip in retaining lug (arrow) and tighten bolt (1) |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- ⚠ Switch off ignition and all electrical consumers.Remove the ignition key. — Remove mirror glass General body repairs, exterior66.
- Remove mirror housing General body repairs, exterior66.
- On inside of mirror housing, remove bolt (1) and unclip retaining lug (arrow).
- Swivel bulb (1) in (direction of arrow) and remove.
- Insert bulb (1) into mirror housing (2)(arrows) and swivel it in (direction of arrow).
- Clip in retaining lug (arrow) and tighten bolt (1) to 1 Nm. — 1 Nm (0.7 lb-ft)
- Check function of turn signal.
- Check function of exterior mirror.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Checking adjustment of accelerator positionsender – VW 2.5 TDI
- Servicing front brakes, 15" wheels, floating frame caliper brakes Lucas RC 54
- Removing and installing brake pedal/brake servo/brake master cylinder
- Renewing bevel box output flange seal
- Checking quantity of fuel delivered
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.